|
Measure
Measure
|
|
Pages available
under the page your currently at, are below. General Categories Available below
|
(1) The first two primary measurement we need is the length and width. Oversize these measurements if not sure. Here’s how… (2) Second is the type of corners– rounded, cut or square. Undersize these measurements if not sure. Here’s how... (3) The skirt or vinyl flap that hangs down the side of the lip of the hot tub. By default if not specified, it will be 2”. This covers the acrylic, protecting it from the sun and wind. It also creates a nice finish to the cover. Try measure within a 1/4 to 1/2 inch of actual skirt required. In other words round up or down, your choice. Here’s how… (4) Any additional measurements that are relevant to your cover. These measurements require complete accuracy of not only these measurements, but all measurements. As the exact location of these are based on your other measurements Pockets in the underside of the cover to accommodate buttons or knobs (usually older spas), Extruding water features, length of locking tie downs if not default. (5) Specify the direction of the hinge, by default the longest measurement either length or width is cut in half. See what I mean… Print out a Dorlon Measurement Sheet. in Adobe PDF format and fax to us. The above file does require Adobe
Acrobat Reader Print out a Sta-Warm Measurement Sheet. Not Available yet If you have any problems or questions, give me a call 604-464-7727 Our fax number if you would like to fax a sketch is 604-942-0685 If you get an answering machine, leave a message. I will call back as soon as I am available to spend time with you on the phone. Usually in the evenings or occasionally on the weekends. So leave a home number, not just an office number. Also mention the best time to call you back if applicable. I do rely heavily on voice mail, detailed messages are always welcome. |
|
Please, please give us your impressions and comments about us or our site. (Click here) Just some of the suppliers and product lines we work with.
Currently working on rebuilding this site completely, to make easier to navigate
and repair broken links.
|
